Cable Industry
Gala is one of the leaders in developing, designing and manufacuting specific Producs in the sector of the Cable Industry. Our Products are designed to provide insulation, mechanical protection and an environmental seal in the Power Cable industry.
Below are the products offered for Cable Industry
Heat Shrink Cable End Caps
Gala's Heat Shrink Cable End Caps are designed to provide Mechanical protection and environmental seal to Power cable ends. It provides a temper proof sealing to cable ends to avoid claims due to cable pilferage.
Cold Shrink End Cap
Cold Shrink End Cap is used to seal the ends of all types of Cables & protect from ingress of water / moisture. The caps are manufactured from high quality EPDM Rubber compatible with most commonly used Cable Jackets i.e. XLPE, PVC, PILC or Rubber Sheathed Cable.
Temperproof Heat Shrink Sealing Caps
Tamperproof Heat Shrink Sealing Caps are used to seal the ends of all types of Cables & to protect it from ingress of water/moisture.
De-gassing End Caps
Gala's De-gassing End Caps are used to seal High Voltage & Extra High Voltage Cables (33 kV & above) to release the constantly evolving gas generated inside the cable during transportation and storage in hot climate conditions.
Heat Shrink Valved End Caps
Gala's Valved Heat Shrink Cable End Caps is used for pressurized application for Telecom Cables.
PVC End Caps
Gala's PVC End Caps are used for Sealing Cable ends of Coaxial, General Cables & Wires.
Heat Shrink Medium/Heavy Wall Tubes
Gala's Heat Shrink Medium/Heavy Wall Tube is used to repair Cable Jackets. It is provides Insulation on the cable pulling eye. This Tubes are made from high quality cross-linked Polyolefin material.
Cold Shrink Tubing
Gala Cold Shrink Tube are open ended, tubular rubber sleeves that are factory expanded and assembled onto a removable core. The core is removed after the tube has been position for installation over and inline connection, terminal lug etc.
Heat Shrink Cable Repair Sleeve
Gala's Heat Shrink Cable Repair Sleeve is manufactured from high-quality cross-linked Polyolefin material. It is folded around the Cable/Wire, tapped up with a Heat resistant tape and then heat shrunk.
Heat Shrink Wrap Around Sleeve
Gala's Wrap Around Sleeve is Cross-linked polyolefin Sleeve which is folded around the cable/pipe, zipped up with a stainless steel channel and then heat shrunk.
Silicone Cable End Seal
Gala's Elastomeric End Seal has been made from specially formulated Rubber Compound and designed to give optimum efficiency to the Curing process in CCV / VCV lines by holding pressure to the desired level. It also helps to neutralize the usage of process water / gas by holding the Cable tight during production runs.
Heat Shrinkable Cable Joints
Gala is one of the leaders in designing and manufacturing Heat Shrink Joints for the most modern PVC/PILC/XLPE/EPR Low & Medium Voltage Power Cable up to 66kV Class.The design specification and quality of our Heat Shrink Cable accessories have been upheld by the most stringent national/International standards worldwide.
Heat Shrinkable Cable Terminations
Gala offers unsurpassed technical superiority for perfect Termination of most modern PVC/PILC/XLPE/EPR Low & Medium Voltage Power Cable up to 66kV Class. We provide CLASS 1 Terminations to Electrical Industries. Our Cable Terminations are made considerably tamper proof from environmental factors as the entire length between the wire termination point and contact is safely encapsulated with this protective product.
High Shrink Ratio Heat Shrink Tube
High-Shrink Ra o HS Tube (GMW 5x) is manufactured from high quality cross inked polyolefin material.
