Heat Shrink Busbar Sleeves - for 66kV

Gala's Heat Shrink Busbar Sleeve is heat shrinkable sleeve designed to insulate busbar systems up to 66KV and also to protect against accidental flash-over. It helps to reduces the air clearance.

Busbar Insulating Boots/Shrouds - Polyolefin

Gala's Polyolefin Busboot is a flexible electrical insulating boot/shroud for busbar and switchgear connections up to 36KV. These pliable boots can be installed, removed or replaced in few minutes. Made from high-quality Polyolefin material to provide excellent electrical insulation and to withstand higher operating temperature continuously.

Busbar Insulating Boots/Shrouds - PVC

Gala's PVC Busboot is a flexible electrical insulating boot/shroud for busbar and switchgear connections up to 36KV. kV. These pliable boots can be installed, removed or replaced in few minutes. Made from specially formulated Polyvinyl Chloride (PVC) material to provide excellent electrical insulation and to withstand higher operating temperature continuously.

Heat Shrink Tape

Gala's Heat Shrink Tape is used for Insulation & protection of medium voltage busbar connections, where tubing cannot be used.

High Voltage Insulation Sheet

Bus Sheet GMHS & GHHS is an adhesive coated heat shrinkable sheet, which provides insulation enhancement & protection against accidentally induced discharge. It is suitable to insulate almost any sizes or shapes of busbar joint like busbar tees, elbows and other connections where tubing and tape can not be used.

Busbar End Caps

Gala's Busbar End Cap is used to cover the end of live Busbars. It is made from Polyvinyl Chloride (PVC) material, it is formulated specially for electrical application at high voltage.

Terminal End Cap

Bushing Boot

Gala's Bushing Boot is used for Insulation & protection of Cable Terminating to Bushing up to 24 KV. It protects against flashovers or surges induced in Switchgear & Transformer boxes.

Insulation Boot for Circuit Breaker

Gala's Insulation Boot for Circuit Breaker is electrrical insulation boots, designed to insulate Draw-Out Circuit Breakers in MV/HV Power Plant & Substations

Heat Shrink Right Angle / Straight Boot

Gala's Angleboots are Heat Shrink Right Angle / Straight Boots provide insulation to the bushings in the cable termination box, where the clearance between phase to phase and phase to earth is less then the normal air clearance. These boots provide protection against flashover in the event of high humidity, rodent menace and surge impulse.

Terminal Protector

Gala's Terminal Protector is an unique insulating system for providing phase to phase to earth insulation to power cable terminals where these terminations need to be installed in very compact areas like Motor Terminal Boxes, Ring Main Units, Distribution Transformers etc.